Back to mods index.
Out of the box this thing is a piece of absoulute sh*T. It gets like 10 feet with one barrel and 20 with another. But when modded.....i'm going to change my tune a little here.
So you want a high powered gun with excellent range, great accuracy, and good reload time. Well what'da know. You have just stumbled upon the AT2K, one of the easiest to mod guns ever made. Upon getting the twin pack of AT2Ks I decided to do 2 mods for the site. This is the second of the 2.
First things first, get the dozen or so screws out. Then, you will notice the gun won't open due to a cap on the end of the gun at the pumping handle. This is what I did, you can do whatever you want. I used a hacksaw at a slight angle while being careful not to cut the pump rod.
As you can see from the above pic its open.
Ok, now plug the release valve with hot glue, which is the hole at the end of the pumping handle, and the one on the side. Be careful with the one on the side because bad glueing could hurt the pumping performance. Now we need to cut the barrel assembly for the addition of CPVC barrels. I used a hacksaw and cut at the line, but you can cut just about anywhere from an 1/2 an inch above the line and almost to the bottom of the barrels. Here is the barrels cut. (sorry about the bad pic)
Ok next, cut 4 6 in. CPVC barrels and glue them on using hotglue, epoxy, or contact cement (a.k.a PVC Cement). Make sure the barrels are on well.
Next, add tape for support, get the gun back together, and you have a gun that gets 90-95 ft. a shot and has great ROF.
Mod by Steven Roughton (Disclaimer: This almost exact same mod has been done on multiple sites, any word, picture, or sentence similarities are coincedental.)
We want to know what you thought of this mod, please post in the forum or E-mail us here.